Sign In | Join Free | My tjskl.org.cn
China sherlinedirect limited logo
sherlinedirect limited
ICP Remarked Supplier
Home >

High-Torque Stepper Motor

High-Torque Stepper Motor

Country/Region china

Company sherlinedirect limited

Categories High Torque Stepper Motor

Update 2018-02-11 03:46:23

ICP License Issued by the Chinese Ministry

Contact Now

Our high-torque stepper motor has the same NEMA #23 frame as our standard stepper motor, but it has over 75% more torque. The increased torque means that you can increase your feed rates. It is also better suited to handle the additional weight of the motor and headstock on our Z-axis.

Plug-and-Play Upgrade

The high-torque stepper motors can also be used on any Sherline CNC machine. The motor is 2 amps, just like our standard motors, so you can easily upgrade your current Sherline system with the new high-torque motors. (For example, Sherline Complete CNC systems or P/N 8760 CNC 4-axis driver box kit.)

NOTE: Referenced upgrades apply only to Sherline products.

Shafts and Flats

Sherline stepper motors have shafts at both ends so that a handwheel can be used for manual control if desired. Flats are ground onto each end of the shaft to accommodate set screws for handwheel and coupling. If a stepper motor is to be used with a Sherline motor mount, the shaft going into the coupling should have a flat machined or ground on it where the set screw bites into it. If this is not done, the point of the set screw can upset the shaft surface sufficiently to make it impossible to remove the coupling. For non-Sherline applications, the flat may not be necessary.

Powerful dual-shaft motors are prewired for quick hookup

Stepper motors have six wire leads pre-wired in a connector that plugs directly into the Sherline linear or rotary controller.

Both the complete CNC system and the P/N 8760 driver box come with 4 cables pre-wired with a 5-pin plug. These match the plugs on the P/N 67127 stepper motors sold by Sherline. To hook up the system all you do is plug each stepper motor into the cable for the proper axis. It couldn’t get much easier than that.

Specifications

Frame sizeNEMA #23
Shaft1/4 diameter, dual shafts
Holding Torque

1.35 N.m (Newton meters)
13.756 kg-cm (kilogram centimeter)
191.17 oz/in (ounce inch)
11.948 in/lb (inch pound)

Axial-ForceFa=15 N Max., or 3.37 lbf Max.
Radial-ForceFr=75 N Max., or 16.86 lbf Max.
Rotor inertia480 g-cm2
Voltage4.5 V DC
Current2 A
Step Angle1.8° (200 steps/rev)
Download PDF 67126 Instructions
Download PDF Removing Stepper Motors


Product Tags:

body building

      
China High-Torque Stepper Motor

High-Torque Stepper Motor Images

Inquiry Cart 0
Send your message to this supplier
 
*From:
*To: sherlinedirect limited
*Subject:
*Message:
Characters Remaining: (0/3000)