Container type oxygen generator Medical oxygen plant
O2 Capacity: 10-60Nm3/h
O2 Purity: 90%-95%
O2 Pressure: 0.5MPa (adjustable)
Dew point:-40C or -60C
1. It has many functions of fault diagnosis, alarm and automatic
2. Optional touch screen display, dew point detection, energy saving
control, DCS communication and so on.
Send email to us
Previous: Industrial oxygen generator PSA oxygen production plantNext: Super Purchasing for China Reliable Air Separation Psa Medical
Oxygen Gas Generation Cylinder Fillin
The compressed air passes through the air purification system to
remove the impurities, such as oil, water and dust, and into the
adsorption tower with zeolite molecular sieve. The nitrogen, carbon
dioxide and water vapor in the air are adsorbed in large quantities
by molecular sieves, and oxygen and nitrogen are separated because
of the high diffusion rate of oxygen.
When the nitrogen and other impurities in the adsorption tower
reach saturation, the pressure is reduced and the zeolite molecular
sieve is regenerated and reused. The two adsorption towers are
operated under the control of PLC and continuously produce high
Adopts labyrinth type air diffuser:
The simple, efficient and reliable airflow diffuser solves the
industrial problem of uneven airflow distribution in the separation
The divides make the inlet gas direction diffusion in three stages:
Firstly, the airflow is firstly deflected by the cyclone, and the
airflow direction is changed from straight through to spiral at the
inlet of the adsorption tower, which can diffuse the airflow around
the adsorption tower and prolong the passage time of the airflow in
the adsorption tower (Adsorption time).
Then, after the diffusion of the diffuser, it is further refined
and uniformly diffused in all directions of the adsorption tower;
Finally, through the uniform gap of alumina, the three-stage
diffusion is carried out to achieve the desired diffusion effect
and then pass through the separation tower bed, make the
utilization rate of the molecular sieve become maximized, and the
gas production efficiency of the equipment is greatly improved.
(1) Because of its high strength, it can prevent direct damage of
the molecular sieve by the inlet airflow, and protect and extend
the service life of the molecular sieve.
(2) Because it is active, it can also absorb impurities such as
moisture and oil mist in the inlet airflow to prevent the molecular
sieve from being contaminated and prolong its service life and
(3) Because of its large particle diameter, it is difficult to leak
from the sealing edge of the lower edge of the separation tower, so
that the molecular sieve loaded on it can be prevented from leaking
directly contacting the sealing portion, thereby functioning to
isolate and seal the molecular sieve.
(4) Since the particles are uniform and large, a large amount of
uniform gap is formed after the accumulation, so that the airflow
passes through it to obtain further uniform diffusion.
Central air extractor
In order to maximize the amount of semi-finished” gas remaining in
each separation cycle in the separation tower to be reused in the
next separation cycle, to reduce waste and energy consumption, we
adopted the root” type central gas extraction structure. The
structure can collect the remaining gas in the tower through a
"root" type branch pipe in a multi-directional, large-area,
uniform, rapid and efficient manner, and finally collects into the
"total branch" and enter another tower for cycle recycling.