- Product features
ZS-NJ-D935W is one kinds of the thermal type of one-component
alcohol silicone sealant which is Room temperature curing. This
products have the properties such as high strength, good adhesion,
good adhesion on alumina, copper, stainess steel and other metal,
excellent dielectric and good heat resistance. The general use of
temperature range is from -60℃～200℃. During the curing process, it
will release the alcohols, which with no corrosion to the materials
such as polycarbonate(PC) and copper. Absolutely compliance with
the EU RoHS’s requisition.
2. The typical use
Chip and heat sink bonding; thyristor intelligent control module
and heat sink bonding; between module and heat sink filled with
high-power electrical bonding.
3. Technical Parameters
Tack-free time (min)
Volume resistivity (Ω·cm)
Dielectric strength (kV/mm)
The above performance data are at 25 ℃, 55% relative humidity
measured after 7 days curing. The company tested different
conditions or product improvements resulting from different data
assumes no responsibility.
- The use of technology
4.1 Surface cleaning:cleaning the sticklied and coated
surface,remove the rust,dirt and oil.
4.2 Brush the glue: Unscrew the hose cap (or cut open), pushed the
glue to clean the surface, evenly distributed so that will be glued
surfaces together and fixed.
4.3 Curing: put the glued or sealed parts in the air and let it be
natural cured. It’s one curing process that cured from the surface
to the internal, in less than 24 hours (at room temperature and 55%
relative humidity) glue curing depth of 2 ~ 4mm, if the sizing
location more deeper, in particular, which is not easily accessible
to the air, then the fully curing time will be extended, if the
temperature is low, the curing time will be extended too, sealant
is fully cured at least 7 days if the thick have 6mm .
After operating, unused glue must be sealed and stored , and
tighten the cap immediately,. if the seal has a little crust when
use it in the next time, remove it and it will not affect the
normal use. During the storage process, the canal orifices may
appear a small amount of the curing phenomenon, cleared it and it
can use it again, and no affection to the product performance.
6. PACKAGING SPECIFICATIONS
100mL / tube,100tubes / box.
7. Storage and transportation
1. 25 ℃ in a cool dry environment six months, more than the shelf
life of the product should be confirmed before use after no
2. Such products are non-dangerous goods, can be transported as
common chemicals. Be careful during transport and prevent the
8. Recommendations and statements
Users are advised to use this product to do first before the formal
suitability test.Because of the diversity of practical application,
our company does not guarantee specific conditions of use of our
products emerging issues, is not liable for any direct, indirect or
accidental loss of user in the course of any problems, you can
contact our service department We will try to assist you.