Customized LCD Precision Large Laboratory Oven For Sale LabTesting
1. The material room
The material is put in the form of pallet structure, and the
material room and the heating room are separated by iron plate.
2. The heating chamber
Install the electric heating equipment, generate the space of hot
air, install the blower in the proper place, and send the hot air
into the material room when the blower runs.
3. Hot air transport mode.
The circulating fan sends the hot air into the hot air passage,
then enters the material chamber through the small holes in the
pallet rack, and adopts the left and right air supply mode to make
the drying more uniform.
4. Heating equipment
Hot air generator, electric heating, finned tube form.
5. Ventilation and dehumidification equipment.
Keep the air in the heating room and the material room circulation
and realize the air exchange in the dryer, and maintain the
equipment for the indoor baking process.Including the cold wind
inlet door, the dehumidifier, and other equipment models different
ventilation and dehumidification equipment.
6. Temperature and humidity control equipment.
Equipment used to detect, display and control the process
conditions of the material baking process, including temperature
sensor, control host and actuator.Through the regulation of heating
equipment, the automatic control of baking is realized.
1. Size and internal dimensions of the box:
1 internal dimension: 420L inner width 700 x 600 x height 1000mm.
2. Power supply voltage: 380V 50/60hz;
3 heating power: about 5KW.
The controller is located above the stand.
5 inner material 304 stainless steel plate, plate thickness of
1.0mm high quality steel plate spray treatment.
6. Thermal insulation material is imported glass rock wool, with
good heat insulation and maximum temperature insulation. It is made
of high temperature resistant silica gel, which can withstand high
temperature of 200 degrees for a long time.
Ii. Temperature control system:
1. Adjustable control within the temperature range of room
temperature ~ 200.
2 precision: control precision
3 plus or minus 2.0 ℃ temperature distribution (light)
4 heating rate: RT ~ 100 (about 10 minutes)
5 for PID temperature control microcomputer automatic calculus of
PV/SV display at the same time, can be in the range of allowable
temperature of the machine according to the personal willingness to
free to set the required temperature, and can be set through the
PID parameter in the table to ensure its accuracy of temperature
control, can also be used by itself in the table of system self
calculus appropriate temperature control parameters are obtained.
The input force CA(K) TYPE output is 12V.
The current controller has no Relay for SSR and maintains high
stability of current.
The hot material is honeycomb stainless steel heating pipe, without
pollution and long service life.
Iii. Air supply system:
By circulation of air forced convection air circulation, 1 are
motor drives the rotor by the electric heater and hot air from
inside air duct to the oven, and will become a source again after
using hot air inhaled air duct heating cycle, thereby reducing
energy loss and the temperature uniformity in the oven, when the
door open and close action cause disturbance, can respond quickly
to supply air circulation system operation state temperature.
2 motor for Taiwan imported long shaft high temperature type, power
The fan is a multi-blade type turbine with high strength, which is
equipped with adjustable guide wind board, so that the wind road
can be run more smoothly.
Iv. Protection device:
1.Ultra-high temperature protection, no fuse switch, porcelain
fuse, motor overload protection.
2.Super - temperature protection, super - load automatic power -
3.Timer: temperature to time, time to power alarm.
4. The warranty period is one year.